Tables; List Of Statements - Siemens SINUMERIK 840Di sl Programming Manual

Tables

12.1

List of statements

Legend:
Default setting at beginning of program (factory settings of the control, if nothing else programmed)
1
The groups are numbered according to the table in section "List of G functions/preparatory functions".
2
Absolute end points: modal (m);
3
incremental end points: non-modal (n);
otherwise: modal/non-modal depending on syntax of G function
As circle center points, IPO parameters act incrementally. They can be programmed in absolute mode with AC. The
4
address modification is ignored when the parameters have other meanings (e.g., thread pitch).
The keyword is not valid for SINUMERIK 810D.
5
The keyword is not valid for SINUMERIK 810D/NCU571.
5
The keyword is not valid for SINUMERIK FM-NC.
7
The OEM can add two extra interpolation types. The names can be changed by the OEM.
8
Extended address notation cannot be used for these functions.
9
Name Meaning
: Block number - main
block (see N)
A Axis
A2 Tool orientation: Euler
5
angles
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Value Description,
comment
0 ... Special
99 999 999 identification of
integers only, blocks, instead
without signs of N... ;this
block should
contain all
statements
required for a
complete
subsequent
machining
section.
Real
Real
Syntax
e.g.,20
12
m/s Group
3 2
m/n
s
431