Siemens SINUMERIK 840Di sl Programming Manual page 481

Group 3: Programmable frame, working area limitation and pole programming
Name No. Meaning
TRANS 1. TRANSLATION: translation, programmable
ROT 2. ROTATION: rotation, programmable
SCALE 3. SCALE: scaling, programming
MIRROR 4. MIRROR: Programmable mirroring
ATRANS 5. Additive TRANSLATION: additive translation, programming
AROT 6. Additive ROTATION: rotation, programmable
ASCALE 7. Additive SCALE: scaling, programming
AMIRROR 8. Additive MIRROR: Programmable mirroring
9. Unassigned
G25 10. Minimum working area limitation/spindle speed limitation
G26 11. Maximum working area limitation/spindle speed limitation
G110 12. Pole programming relative to the last programmed setpoint position
G111 13. Polar programming relative to origin of current workpiece coordinate
system
G112 14. Pole programming relative to the last valid pole
G58 15. Programmable offset, absolute axial substitution
G59 16. Programmable offset, additive axial substitution
ROTS 17. Rotation with solid angles
AROTS 18. Additive rotation with solid angles
Group 4: FIFO
Name No. Meaning
STARTFIFO 1. Start FIFO
Execute and simultaneously fill preprocessing memory
STOPFIFO 2. STOP FIFO,
Stop machining; fill preprocessing memory until STARTFIFO is detected,
FIFO full or end of program
FIFOCTRL 3. FIFO CTRL,
Preprocessing memory control
Group 6: Plane selection
Name No. Meaning
G17 1. Plane selection 1st - 2nd geometry axis
G18 2. Plane selection 3rd - 1st geometry axis
G19 3. Plane selection 2nd - 3rd geometry axis
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
12.3 List of G functions/preparatory functions
X m/n
X n
X n
X n
X n
X n
X n
X n
X n
X n
X n
X n
X n
X n
X n
X n
X n
X n
X m/n
X m/n
Tables
SAG MM
SAG MM
m Def.
m
m
SAG MM
m Def.
m
m
481