Delete Additive Offsets (Deldl) - Siemens SINUMERIK 840Di sl Programming Manual

8.16.3

Delete additive offsets (DELDL)

Function
DELDL is used to delete the additive offsets for the tool edge of a tool (in order to release
memory). Both the defined wear values and the setup values are deleted.
Programming
status = DELDL [t,d]
Parameters
DELDL [t,d]
DELDL[t]
DELDL
status
Note
The wear and setup values of active tools cannot be deleted (behave similar to deletion of D
or tool data).
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
All additive offsets of the tool edge with D number d of tool t are deleted
All additive offsets of all tool edges of tool t are deleted
All additive offsets of the tool edges of all tools of the TO- unit are
deleted (for the channel, in which the command is programmed)
0: Offsets have been successfully deleted.
–: Offsets have not been deleted (if the parameter settings specify
exactly one tool edge), or not deleted completely (if the parameter
settings identify several tool edges).
Tool offsets
8.16 Additive offsets
397