Feedrate Control And - Siemens SINUMERIK 840Di sl Programming Manual

Feedrate Control and Spindle Motion
7.1 Feedrate (G93, G94, G95 or F..., FGROUP, FGREF)
Note
Programming
G93 or G94 or G95
F...
or
FGROUP (X, Y, Z, A, B, ...)
Or
FL[axis]=...
or
FGREF[axis name]=reference radius
Parameters
G93
G94
G95
F...
FGROUP
FL
FGREF
Axis
X Y Z
A B C
270
The inverse-time feedrate 1/min G93 is not implemented for 802D.
Inverse-time feedrate 1/rpm
Feedrate in mm/min or inches/min or in deg/min
Feedrate in mm/rev or inches/rev with reference to the speed of the master
spindle – generally the cutting spindle or the main spindle on the turning
machine
Feedrate value in unit defined by G93, G94, G95
Feedrate value F valid for all axes specified in FGROUP
Limit speed for synchronized/path axes; the unit set with G94 applies
(max. rapid traverse) One FL value can be programmed per axis. The axis
identifiers of the basic coordinate system must be used (channel axes or
geometry axes).
Effective radius (reference radius) for the rotary axes entered in FGROUP
Channel axis or geometry axes or orientation axes
Movement of the specified geometry axis
Axis identifier for rotary axis to be traversed
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Fundamentals