Siemens SINUMERIK 840Di sl Programming Manual page 506

Tables
12.4 List of predefined subprograms
25. Synchronous spindle
1st para-
meter
COUPDEF AXIS:
# Followin
g axis or
following
spindle
(FS)
COUPDEL # AXIS:
Followin
g axis or
following
spindle
(FS)
COUPOF # AXIS:
Followin
g axis or
following
spindle
(FS)
COUPOF # AXIS:
Followin
g axis or
following
spindle
(FS)
COUPOF # AXIS:
Followin
g axis or
following
spindle
(FS)
506
2nd 3rd para- 4th para-
para- meter meter
meter
AXIS: REAL: REAL:
Leadin Numerat Denomin
g axis or ator
or transfor transfor
leading mation mation
spindle ratio (FA) ratio (LA)
(LS) or (FS) or (LS)
AXIS:
Leadin
g axis
or
leading
spindle
(LS)
AXIS:
Leadin
g axis
or
leading
spindle
(LS)
AXIS: REAL:
Leadin POS
FS
g axis
or
leading
spindle
(LS)
AXIS: REAL: REAL:
Leadin POS POS
FS
g axis
or
leading
spindle
(LS)
5th parameter
Block change behavior
STRING[8]: Block change behavior:
"NOC": no block change control,
block change is enabled
immediately, "FINE": block change
on "synchronism fine", "COARSE":
block change on synchronism
coarse and "IPOSTOP": block
change in setpoint-dependent
termination of overlaid movement. If
the block change behavior is not
specified, the set behavior is
applicable and there is no change.
The block change is enabled
immediately.
Block change is not enabled until
this position has been crossed.
Block change is not enabled until
both programmed positions have
LS
been crossed. Range of
POS , POS : 0 ... 359.999
FS LS
degrees.
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
6th Explanation
parameter
STRING[2]: Couple
"DV": definition:
Setpoint definition of
coupling synchronized
"AV": spindle grouping
Actual-
value
coupling
Couple delete:
Delete
synchronous
spindle group
Fastest possible
deactivation of
synchronous
operation.
Deselection of
synchronous
operation after
deactivation
position POS
has been
crossed
Deselection of
synchronous
operation after
the two
deactivation
positions
POS and
FS
POS have
LS
been crossed.
Fundamentals
FS