Menu Description - Ricoh SP 330DN Field Service Manual

5.System Maintenance
Menu
Size Adjust
Factory Default
Menu
Factory Return
Default
Execute Resets all the settings to factory default.
CTL Maintenance
Menu
PDL Mode ON = "PDL Settings" is shown in [Print List/Report] menu (Default)
OFF = "PDL Settings" is hidden
FW Update If updating firmware on a machine in which LDAP authentication is set, execute this
Mode mode.
[Execute/ Return]
After pressing "Execute", the display shows "Please Restart Machine...." Turn the
machine's main power off, and then on. Then the machine activates in a special boot
loader mode. After that, update the firmware via USB cable.
Auto IP ON = Automatically set an IP address when an IP address cannot be acquired
(Default)
OFF = Continually try to obtain an IP address by DHCP
Disable Sets whether the USB port function is valid or invalid
USB Port [Off (Default)/On]
Paas When used to set Paas (Only for CHN)
110
Flatbed Sub Reg.
ADF Main Reg.
ADF Sub Reg.
Flatbed Main Reg.
Flatbed Sub Reg.
Does not execute anything. Returns to an upper level.
Clears/ resets the contents of the controller memory (all data programmed
by the user, log data application counters) to factory default.
After executing, initial setup menu starts after power-on.
[-2.0 to 2.0 / 0 (Default)/ 0.1mm/step]
Adjusts the Flatbed Scan sub-scan registration.
[-2.0 to 2.0 / 0 (Default)/ 0.1mm/step]
Adjusts the ADF Scan main-scan magnification.
[-0.9 to 0.9 / 0 (Default)/ 0.1 %/step]
Adjusts the ADF Scan sub-scan magnification.
[-0.9 to 0.9 / 0 (Default)/ 0.1 %/step]
Adjusts the Flatbed Scan main-scan magnification.
[-0.9 to 0.9 / 0 (Default)/ 0.1 %/step]
Adjusts the Flatbed Scan sub-scan magnification.
[-0.9 to 0.9 / 0 (Default)/ 0.1 %/step]
Description
Description
Description