Poor Printing (Offset) - Ricoh SP 330DN Field Service Manual

6.Troubleshooting
[A]: Paper feed direction
[B]: Image area of the drum
Solution
When there are gaps between the paper and the side or the end fences of the paper tray, adjust the
side or the end fences of the paper tray to remove the gaps.
If the problem still exists, set [Interval Setting] of SP. Refer to
Curled after Printing".

Poor Printing (Offset)

Problem
Poor printing (offset) may occur.
Causes
The fusing temperature is too high for some paper types.
Solutions
When poor printing occurs with the same paper types, change the settings of the fusing temperatures of
the paper type in the following SPs.

When occurring with Plain/Thin paper: Set the fusing temperature 5 degrees lower.
Four-line LCD panel: SP menu > [Engine Maintenance] > [Fusing Unit Temperature] > [Plain
paper]/[Thin Paper]s
Touch panel: SP menu > [Engine Service Setting] > [Fusing Unit Temperature] > [Plain paper]/[Thin
Paper]

When occurring with Thick 1 paper: Set the fusing temperature 5 to 10 degrees lower and make
sure that toner has fused sufficiently on the printed paper.
Four-line LCD panel: SP menu > [Engine Maintenance] > [Fusing Unit Temperature] > [Thick1 Paper]
Touch panel: SP menu > [Engine Service Setting] > [Fusing Unit Temperature] > [Thick1 Paper]
When offset occurs with a specific paper type, change the target paper type (without changing the
196
"Recycled or Thin Paper Is Severely