Troll-User-Selected Data Area; Troll Navigation - Mercury VesselView 7 Manual

• RPM set‑point
• RPM sweep color will change to orange when active to indicate the engine is computer controlled.
a
Troll—User-Selected Data Area
Troll will modify the user‑selected data area of the screen when active.
• Elements within the user‑selected data area will change to allow the user to set‑up:
a. RPM set‑point
b. Troll status enable or disable
a
b
c

Troll Navigation

Troll mode will have a modified navigation system similar to Smart Tow. The user‑selected data area footer allows the operator
to enable or disable troll, minimize, or exit the program element. Footer navigation will follow the same basic navigation
selection strategy as other features.
1. Use the arrow buttons to go through the selections in the footer.
2. Press enter to activate the selection.
a. Enable or disable the element feature.
b. Minimize will hide the troll data and display TROLL in the system status field. This allows the operator to display
information from other selected icons.
3. The set‑point adjustment selection field will be the default location at troll start‑up. After the operator makes adjustments to
the desired settings, use the arrow buttons to the enable/disable selection in the user‑selected data area footer.
a. Use the arrow buttons to move between the set‑point selection and the footer.
b. When the selection tab is above the footer navigation area (set‑point field), the operator only needs to use the arrow
buttons to make RPM or speed adjustments. There is no need to press enter to engage the new setting.
4. Minimize is a feature that allows the operator to use the troll feature while displaying additional data in the user‑selected
data area.
IMPORTANT: Set‑points cannot be adjusted when troll is minimized.
a. Scroller bar icon selection is limited. Items that are not accessible will be grayed out when troll is active.
b. If autopilot is active, and troll is minimized, the system status field will display TROLL.
• Troll data will be displayed over autopilot settings if the user selects the system status field.
• If an autopilot pop‑up notification occurs or the operator uses the autopilot CAN trackpad, autopilot data will
automatically fill the user‑selected data area. The operator will have to minimize to hide the pop‑up data.
5. After minimize is activated, the system status field will display TROLL.
6. When exit is selected while displaying troll element, the troll feature will be disabled. The troll icon will be displayed next to
the system status field until another icon is selected from the scroller bar.
90-8M0087258 DECEMBER 2014
eng
b
52278
a - Set‑point value
b - Enable or disable
c - Minimize
d - Exit
d
52457
Section 3 - Screen Overview and Operation
a - Not active
b - Active
Page 45