Mercury VesselView 7 Manual page 54

Section 4 - Setup and Calibrations
4. Set various smart contextual limits
5. Turn off or on supported data for each engine
6. Select the number of SmartCraft networks and the network number
The greater‑than sign ( > ) indicates additional menu choices.
Number of engines >
Depth Offset >
Sea Temperature >
Speed >
Steering >
Location: port, port center,
Tanks >
starboard center, starboard >
Page 50
SmartCraft
Select 1–4
Calibration: offset,
zero, restore
None, PCM0,
PCM1, PCM2,
Sea temperature
PCM3, AirMar0,
source >
AirMar1, AirMar2,
AirMar3
Calibration: offset,
Offset >
zero, restore, save
GPS source > CAN‑P or H
None, PCM0,
Pitot speed source
PCM1, PCM2,
>
PCM3,
Pitot sensor type > 100 or 200 PSI
Calibration:
Pitot multiplier > multiplier and
restore, save
None, PCM0,
Paddle speed
PCM1, PCM2,
source >
PCM3
Paddle speed
Legacy or Airmar
sensor >
Calibration:
Paddle frequency > multiplier and
restore, save
None, PCM0,
Steering angle
PCM1, PCM2,
source >
PCM3, TVM
Turn on (check
mark) to invert
steering, or off (no
Invert steering
checkmark), which
engine to show
steering
Calibration: offset,
Offset >
zero, restore, save
Tank 1 or 2 > Calibration >
None, fuel, oil,
Tank usage >
water, waste
Capacity > 0 up to six digits
— —
— —
—
—
—
—
—
—
—
—
—
—
—
—
Empty, 1/4, ½, 3/4, full
—
—
90-8M0087258 DECEMBER 2014
eng