Easy Links; Alarms; Units; Network - Mercury VesselView 7 Manual

Section 4 - Setup and Calibrations

Easy Links

Vessels with SC 100 gauges must have the easy links enabled (check mark) in VesselView for data to be received at the SC
100 gauge.
Easy Link
Port, Port Center, Starboard Center, Starboard
>

Alarms

Alarms allows you to check the history for any alarm, turn a specific alarm on or off, or show all the alarms.
Alarms >

Units

Units allows you to select the type of measurement for the various SmartCraft network sensors: English, metric, nautical,
magnetic or true heading, miles per gallon, liters per kilometer and more.
The greater‑than sign ( > ) indicates additional menu choices.
Distance >
Distance small >
Speed >
Winds speed >
Depth >
Altitude >
Units >
Heading >
Temperature >
Volume >
Economy >
Pressure >
Barometric pressure > Hg, mbar, kPa

Network

1. Auto Select, Sources and Magnetic Variation:
Page 52
Engine and Transmission >
RPM sync
Fuel tank 1
Fuel tank 2
Oil tank
Fresh Water
Waste water tank >
Alarm History
Alarms Settings >
Show all helm alarms
Nautical, kilometer, mile
Feet, meter, yards
Knots, kilometer per hour, miles per hour
Knots, kilometer per hour, miles per hour, meters per second
Meters, feet, fathoms
Meters, feet
Magnetic, true
Centigrade, Fahrenheit
Liters, gallons
Distance/volume, volume distance, miles per gallon, gallons per mile, kilometer per liter, liter
per kilometer
Hg, mbar, psi, kPa
Port or Starboard–On (checkmark), off (no
checkmark)
On (checkmark), off (no checkmark)
On (checkmark), off (no checkmark)
On (checkmark), off (no checkmark)
On (checkmark), off (no checkmark)
On (checkmark), off (no checkmark)
Gray tank 1, Black tank 1 On (checkmark), off
(no checkmark)
Shows legacy alarms
No GPS fix, Shallow water, Deep water, Water temp
rate, Anchor, Anchor depth, low boat speed, Speed
through water rationality fault, XTE, Waypoint
radius, Arrival, True wind shift, True wind high, True
wind low, Fuel remaining low, Fuel remaining high,
Voltage >, Missing data >, Vessels >, Autopilot >,
Engines >
NOTE: These settings must be enabled to receive

alarms.

On (checkmark), off (no checkmark)
90-8M0087258 DECEMBER 2014
eng