Mercury VesselView 7 Manual page 55

Location: port, port center,
Trim >
starboard center, starboard >
Tab source >
Tabs >
Starboard and port calibration
Enable
Engine running threshold >
Slow demand threshold >
Fast demand threshold >
Smart contextual >
Lever shift threshold >
Mode timer threshold >
Mode stable threshold >
Steady state threshold >
RPM, fuel rate, coolant temp,
oil temp, oil pressure, water
pressure, battery voltage,
Limits >
intake temp, boost pressure,
transmission oil pressure and
temperature >
Location: port, port center,
Supported data >
starboard center, starboard >
Advanced > Number SmartCraft network >
Network number >
90-8M0087258 DECEMBER 2014
eng
SmartCraft
Turn on (check
Has trim mark) or off (no
checkmark)
Set trim in,
maximum trim
Calibration >
range, full trim out,
reset, restore, save
None, PCM0,
PCM1, PCM2,
PCM3, TVM
Number of Set tab down, mid,
calibration points (2 up range, reset,
or 3), restore, save
Turn on (check
mark) or off (no
checkmark)
Set limit
Set limit 0–99 %
Set limit 0–99 %
Set limit 0–99 %
Set limit 0–10.0
seconds
Set limit 0–10.0
seconds
Set RPMs per
second
Set the limits:
minimum,
maximum, warning
low, warning high,
reset, save for
each engine.
Actual gear, boost
pressure, fuel
pressure, gear
pressure, gear
temperature, load
percent, manifold Turn on (check
temperature, MIL mark) or off (no
(malfunction checkmark)
indicator lamp), oil
pressure, oil
temperature,
throttle present,
water pressure
1 or 2
Used with vessels
with more than 1
SmartCraft network
A or B
Used to identify the
network
Section 4 - Setup and Calibrations
—
—
— —
—
— —
— —
— —
— —
— —
— —
— —
— —
— —
—
— —
— —
Page 51