Siemens SIPROCESS GA700 Operating Instructions Manual page 116

Maintenance and service
10.1 Safety instructions
Note
Different IP address when replacing the processing module
Having different IP addresses after replacing the processing module can prevent network
communication with the device.
If you install a new processing module in the SIPROCESS GA700 device, the following IP
address is set as default in the factory: 192.168.0.2. Before you set up a network connection
to the device, follow the steps below:
● Check the IP address
● Set the IP address again prior to module replacement
You will find information on setting the IP address in the operating manuals (→ List of
references).
116
Rack-mounted device
Operating Instructions, 05/2015, A5E31874006-03