Table of Contents
Advertisement
Installation test cycle
Your washer must be correctly installed before use. Check the installation and operation of the washer using the
following procedure:
1. Touch 'Power'
to activate your washer.
2. Touch both the
and 'Options' buttons at the same time, and hold for three seconds.
3. Touch
to start the installation test cycle. The display will show
.
4. The washer will beep to signal the end of the installation test cycle. Any faults will be displayed on the screen
(refer to the back of this user guide to help identify faults). If you need further assistance, please contact a
Fisher & Paykel Authorised Repairer or our Customer Care Centre. Refer to 'Customer Care' section for
contact details.
If there are no faults found, the washer will automatically turn off at the end of the
installation test cycle.
Available from your Fisher & Paykel dealer or a Fisher & Paykel Authorised Repairer.
Hose Inlet
Long (2 m)
Hose Inlet
Large Bore
Drain Hose
https://producthelp.fisherpaykel.com/au/Wash/Top_Loaders/CleanSmart/WL8060P1/User_Guide_WL8060P1/03_Installation_...
Accessories and Spare Parts
Part No. 422680P
Part No. 426123P
Part No. 425627P
Updated: Fri, 14 Feb 2020 17:08:14 GMT
Powered by
9
Advertisement
Table of Contents
