Table of Contents
Advertisement
Your washer does not have
an internal heater to heat
water.
Levelling instructions
It is IMPORTANT to level the washer to ensure good spin performance.
A spirit level is provided with your washer. Use this to level your washer, always placing it on a clean, flat surface.
The washer is level when the bubble sits in the centre, within the two lines.
Your washer is equipped with self-locking feet at the front to ensure they do not move once you have levelled
your washer. To adjust the feet, tilt the washer back and twist to move them up or down.
After levelling, the corners of the washer should be clear of the floor and the washer must
not rock in any direction.
1. Move the washer to its final position using the top
corners to manoeuvre the product into place (do
not push on the centre front of the washer). We
recommend a minimum clearance of 20 mm each
side and 40 mm at the rear of the washer.
2. Open the lid, place the spirit level at the
centre front of the top deck forward of the lid lock
slot. Level the washer from side to side by winding
up or down the front feet (Fig.1).
3. With the lid closed, tilt the washer forward away
from the wall approximately 100 mm (Fig.2), the
self-adjusting feet will release. Gently lower the
washer back down.
4. Open the lid, place the spirit level at either the right
hand or left hand side of the top deck. Level the
washer from front to back using the front feet only
(Fig.3), winding both feet in or out equally. Tilt the
washer forward again and lower back down (Fig.2).
5. Re-check the washer is level. Move the spirit level
around to all positions once more, checking the
https://producthelp.fisherpaykel.com/au/Wash/Top_Loaders/CleanSmart/WL8060P1/User_Guide_WL8060P1/03_Installation_...
Fig.1 Levelling side to side
Updated: Fri, 14 Feb 2020 17:08:14 GMT
Powered by
7
Advertisement
Table of Contents
