the hose connections for leaks again after 24 hours.
• Uncoil power cord, remove and discard the plastic pin cover, and plug into wall socket.
• Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
Do not touch or operate the washer with wet hands or with bare feet.
Installation test cycle
Your washer must be correctly installed before use. Check the installation and operation of the washer using the
following procedure:
1. Touch 'POWER' to activate your washer.
2. Touch both the and 'Options' buttons at the same time, and hold for three seconds.
3. Touch to start the installation test cycle. The display will show and the lid will lock.
4. The washer will beep to signal the end of the installation test cycle. If there are no faults found, the washer will
automatically turn off at the end of the installation test cycle. Any faults will be displayed on the screen (refer to
'Fault
Codes'). If you need further assistance, please contact a Fisher & Paykel trained and supported service
technician or our Customer Care Centre. Refer to
WA7060M QuickSmart™ washer only – a manual check of the inlet hose connections will be
required as the installation test cycle will not verify if the hot and cold inlet hoses are connected the
correct way around.
Available from your Fisher & Paykel dealer or a Fisher & Paykel trained and supported service technician.
Blanking
Cap
Hose Inlet
Long (2
m)
Hose Inlet
Large
Bore
https://producthelp.fisherpaykel.com/nz/Wash/Top_Loaders/WashSmart_Eco/WA8560E1/User_Guide_WA8560E1/03_Install...
'Customer
Accessories and Spare Parts
Part No. 388491P
Part No. 422680P
Part No. 426123P
Care' section for contact details.
Updated: Wed, 06 May 2020 16:00:17 GMT
Powered by
9