Table of Contents
Advertisement
Inlet hoses
Failure to adhere to the
following instructions may
result in a flood and
damage to property:
1. Connect the straight ends of the inlet hoses to the
taps (there are washers fitted in both ends).
Connect the red connector hose to Hot, and the
white connector hose to Cold.
2. Connect the elbow ends of the inlet hoses to the
corresponding washer inlet valves.
marked on the back of the washer. Ensure the Hot
valve is connected to the hot tap and the Cold
valve is connected to the cold tap.
H = Hot C = Cold
This clothes washer should be plumbed into both a hot
and cold water supply otherwise some cycles may not
function correctly.
https://producthelp.fisherpaykel.com/au/Wash/Top_Loaders/CleanSmart/WL8060P1/User_Guide_WL8060P1/03_Installation_...
• New hose sets provided
with the washer shall be
used to connect the
washer to the water
supply.
• Old hose sets should not
be used.
• We recommend replacing
the inlet hoses every 5
years.
• Hoses should be checked
from time to time and
replaced if any wear, cuts,
bulges, kinks or leaks are
found.
Inlet
valves are
Inlet hose ends
Updated: Fri, 14 Feb 2020 17:08:14 GMT
Powered by
6
Advertisement
Table of Contents
