Table of Contents
Advertisement
3. Place the drain hose in the tub or standpipe. Do
not fit the hose to a drain spigot. Drainage must not
be airtight in order to prevent siphoning.
Electrical connection
• This appliance must be supplied with a 220 – 240 V, 50 Hz, sinusoidal, 10 A electrical supply.
• Check the power cord for damage, making sure it is not squashed or twisted.
• A damaged power cord must be replaced by a Fisher & Paykel Authorised Repairer, in order to avoid a hazard.
The appliance must not be operated until it is repaired, as there is a risk of electric shock.
Draining
• Regularly check that your standpipe or tub is free from lint or other obstructions, which may affect how your
washer works or may cause flooding.
• In multi-storey apartments or any upper floor, the washer should be installed on a floor equipped with a drain.
• Draining must comply with local by-laws.
Water supply
Your cold water should not exceed 35°C and your hot water should not exceed 65°C.
Temperatures above these may cause the washer to fault or cause damage to the washer.
• If you have an uncontrolled water heating source (eg a wet back or solar heating system) you should fit a
tempering valve. This will ensure the hot water temperature remains within safe limits. Contact your registered
plumber to select and install the tempering valve.
• Inlet water static pressure: Max. 1 MPa (150 psi) Min. 34 KPa (5 psi)
• Inlet water flow rate at tap: Min. 6 litres/min.
• This appliance must be installed in accordance with the installation instructions before use.
• Provide accessibility of the plug or incorporate a switch in the fixed wiring in accordance with the
• Do not operate this washer if it has been damaged during transport. Contact your Fisher &
https://producthelp.fisherpaykel.com/au/Wash/Top_Loaders/CleanSmart/WL8060P1/User_Guide_WL8060P1/03_Installation_...
wiring rules to allow disconnection of the appliance from the supply after installation.
Paykel dealer or Fisher & Paykel Authorised Repairer.
Updated: Fri, 14 Feb 2020 17:08:14 GMT
Powered by
5
Advertisement
Table of Contents
