Table of Contents
Advertisement
Please ensure that the base packer has been removed BEFORE OPERATING your
washer.
Location
Install the washer on a solid and level floor surface ensuring it has at least 20 mm
clearance on each side. The washer must not be installed on any textured floor coverings
(eg carpets, rugs).
In your clothes washer you will find:
• 1 hose guide.
• 2 inlet hoses.
Drain hose
1. Carefully pull the drain hose out from the back of
the washer by pulling the exposed part of the hose
downward and outward.
2. To guide the drain hose over the tub or standpipe
the hose guide MUST be fitted to the drain hose.
To prevent siphoning the
drain hose should not
extend more than 20 mm
from the end of the guide.
The height of the standpipe
or tub should be between
850 – 1200 mm. The
drainhose can be trimmed
to length.
https://producthelp.fisherpaykel.com/au/Wash/Top_Loaders/CleanSmart/WL8060P1/User_Guide_WL8060P1/03_Installation_...
Fitting the drain hose guide
Updated: Fri, 14 Feb 2020 17:08:14 GMT
Powered by
4
Advertisement
Table of Contents
