Lan Connection; Lan For Operation Management (Mnt Port) - Fujitsu ETERNUS DX60 S4 Design Manual

2. Connection Configuration

LAN Connection

LAN Connection
The ETERNUS DX requires a LAN connection for operation management.
In addition, information such as ETERNUS DX failures is notified to the remote support center.
Make sure to connect each controller to the LAN for operation management.
Specifications for the LAN ports of the ETERNUS DX are shown below.
Operation Mode
•
Ethernet (1000BASE-T/100BASE-TX/10BASE-T)
• Internet Protocol
IPv4 and IPv6 are supported.
■
IP Addresses for the ETERNUS DX
In order to connect to the LAN for operation management, an IP address for ETERNUS DX must be prepared in
advance.

LAN for Operation Management (MNT Port)

In an ETERNUS DX, the system administrator logs on to the ETERNUS DX via a LAN to set the RAID configuration,
manage operations, and perform maintenance.
In addition, the failures that occur in the ETERNUS DX are notified to the remote support center. The remote
support uses MNT ports for a network connection by default. In this situation, the network connection for the
remote support is transferred via the LAN for operation management. When the network connection for the re-
mote support needs to be separated from the LAN for operation management, refer to
(RMT Port)" (page 109)
FUJITSU Storage ETERNUS DX60 S4, ETERNUS DX60 S3 Hybrid Storage Systems Design Guide (Basic)
and use the RMT ports to connect to the remote support center via a different network.
107
Copyright 2019 FUJITSU LIMITED
"LAN for Remote Support
P3AM-8992-14ENZ0