Remote Connection - gefran eView BOX Installation And Instruction Manual

Network
Press the Network button to configure the various network
ports.
The following page appears:
The first pull-down menu shows the available network ports
(ex.: ETH #1). The second pull-down menu shows the
protocols that can be used (disabled, TCP/IP or GdNet) with
that port.
If required by the protocol, the panel to configure the IP
address and subnet mask also appears.
The default IP address is 192.168.0.1.
To change a data item, touch the item in question with your
finger. A number pad appears.
Enter the new item and confirm with OK, or cancel the
operation with CANCEL.
The gateway section lets the device communicate with IP
addresses of different subnetworks. You have to enable
and then configure the IP address of the gateway server in
the subnetwork to which the device has been connected.
The address to be configured must therefore match the IP
subnetwork configured for ETH1.
The save and cancel buttons activate if changes are made.
Changes are applied only when the application program is
rebooted.
Attention: After saving, you cannot recover old
data (no UNDO function).
Press Home to return to the main menu. Press <<-back to
return to the previous menu.
80949_MAN_eView BOX_05-2019_ENG

Remote Connection

The device supports web and vnc remote communication
management.
Web and vnc management have to be configured in GF
Project VX programming environment; see the Remote
Connections paragraph in the GF Project VX manual.
These managements function correctly only if the device for
access to Ethernet via TCP/IP is properly configured and
connected (see Network configuration).
In this section you can enable and disable these managements
on the device in use and configure parameters (which can be
specific for the individual device).
Enable vnc start: Activates or deactivates vnc management;
activation requires configuration of a password for access,
which will have to be used by the vnc client remote connection.
To confirm changes to the configuration, click SAVE CHOICE.
SNTP/NTP time server
You can configure the device to synchronize date and time
with a more precise source accessible on the TCP/IP network
via SNTP/NTP.
These managements function correctly only if the device for
access to Ethernet via TCP/IP is properly configured and
connected (see Network configuration).
In this section you can enable and disable this management.
You have to configure the IP address and the port number of
the SNTP/NTP server.
You can configure a correction value expressed in seconds
to be added to the date and time supplied by the SNTP/ NTP
server.
The DST selection lets you activate or deactivate the 1-hour
25