Table 22 Advanced Setup - Nortel BSR252 Configuration - Basics

126 Chapter 7 WAN screens
Table 22

Table 22 Advanced Setup

Label
AT Command
Strings
Dial
Drop
Answer
Drop DTR When
Hang Up
AT Response
Strings
CLID
Called ID
Speed
Call Control
Dial Timeout (sec) Type a number of seconds for the Business Secure
Retry Count
Retry Interval
(sec)
Drop Timeout
(sec)
Call Back Delay
(sec)
NN47923-500
describes the fields in
Description
Type the AT Command string to make a call.
Type the AT Command string to drop a call. ~
represents a one-second wait. For example,
~~~+++~~ath can be used if your modem has a slow
response time.
Type the AT Command string to answer a call.
Select this check box to have the Business Secure
Router drop the DTR (Data Terminal Ready) signal
after the AT Command String: Drop is sent out.
Type the keyword that precedes the CLID (Calling
Line Identification) in the AT response string. This lets
the Business Secure Router capture the CLID in the
AT response string that comes from the WAN device.
CLID is required for CLID authentication.
Type the keyword preceding the dialed number.
Type the keyword preceding the connection speed.
Router to try to set up an outgoing call before timing
out (stopping).
Type a number of times for the Business Secure
Router to retry a busy or no answer phone number
before blacklisting the number.
Type a number of seconds for the Business Secure
Router to wait before trying another call after a call
has failed. This applies before a phone number is
blacklisted.
Type the number of seconds for the Business Secure
Router to wait before dropping the DTR signal if it
does not receive a positive disconnect confirmation.
Type a number of seconds for the Business Secure
Router to wait between dropping a callback request
call and dialing the corresponding callback call.
Figure 32.
Example
atdt
~~+++~~ath
ata
NMBR
CONNECT
60
0
10
20
15