Nortel BSR252 Configuration - Basics page 224

224 Chapter 13 VPN
Table 54 VPN Branch Office rule setup
Label
Available/ Selected IP
Policy
Private IP Address
NN47923-500
Description
The Available IP Policy table displays network routes. Use the
Add, Edit and Delete buttons to configure this list.
Move the network routes that you want to use the VPN tunnel
down into the Selected IP Policy table.
Select a network route's radio button in the Available IP Policy
table, then click the down arrows to move it into the Selected IP
Policy table. To remove a network route from the Selected IP
Policy table, select its radio button in the Selected IP Policy
table and click the up arrows.
A network route that is already selected for a VPN tunnel does not
display in the Available IP Policy table.
This field displays the IP address (or a range of IP addresses) of
the computers on your Business Secure Router's local network,
for which you have configured this VPN rule. For a range of
addresses, the starting and ending IP addresses are displayed
separated by a dash.
This field applies when you configure the IP policy to use a branch
tunnel NAT address mapping rule in the IP Policy screen.
This field displays a single (static) IP address when the IP policy's
Branch Tunnel NAT Address Mapping Rule Type field is
configured to One-to-One in the IP Policy screen.
This field displays the beginning and ending (static) IP addresses
of a range of computers when the IP policy's Branch Tunnel NAT
Address Mapping Rule Type field is configured to Many-to-One
or Many One-to-one in the IP Policy screen.