Downloading Via Local Network - Xerox MF Series Technical Document

IG 252 787 467 - A
- Click on <Emettre> (send): the transmission is effected when it reaches the top of the
transmission queue.
• The Quadrige calls the fax. If the connection is made, the fax displays Téléchargement en cours
(download in progress) and the comm. pictograph is displayed. The communication can take
about 23 minutes for a software of about 2000 kbytes. At the normal end of the communication
the machine should not reboot immediately. If this occurs, there are two possibilities:
- The file is corrupted (wrong checksum) or the software is not compatible with the MFL
machine, and the machine reboots with the software that was already installed. Check the
file and restart the procedure.
- The communication has been interrupted. Check the number of the fax, skip step 1 and
directly restart the communication.
• After approximately 40 seconds, the machine switches itself off, then switches on again.
The PLEASE WAIT message is displayed.
• Check the software version and the soft checksum by typing MENU * V. Or check the software
version and the miniboot checksum by typing MENU * B or soft modem MENU * M and fonts
checksum MENU * F.
7.4.3 D
OWNLOADING VIA
This procedure requires an Ethernet cable and a PC equipped with a LAN card and the Outlook express
software.
• Create an Outlook Express account:
- Launch Outlook Express.
- In the Tools menu, select Accounts . The window Internet Accounts appears.
- Click on the Add button and select Mail.
- Type "toto" in the Display Name field and click on Next.
- Type "toto@toto" in the Email Adress field and click on Next.
- Type the address "169.254.0.1" in the Incoming Mail Server field and Outgoing Mail Ser-
ver field and click on Next.
- Type "toto" in the Account Name field and click on Next and Finish.
• Check the account connection:
- Select the newly create account in the Internet accounts list and click on the Properties.
- In the Connection tab, tick the Connect using my local area network (LAN) "Local
Network" checkbox and click on OK.
• Connect the PC and the terminal to the Ethernet cable.
• Perform the downloading process following the steps bellow:
- Modify the terminal IP adress following the steps bellow:
- Go to the menu:
- Type 169 254 000 001 then OK and STOP.
- Position the SOS Softswitch bit 8 at 1:
- Switch to the download mode:
sage.
- Create a message (using Outlook Express) on the PC destinated to "toto@toto" and attach to
it the file containing the software to download to the terminal . Send the message.
The terminal LCD screen displays the TELELOADING message.
At the end of download, the terminal reboots.
- 20 -
L N
OCAL ETWORK
, 2, 5, 3, 2 then OK.
, *, T. The machine displays the WAITING @ LOAD mes-
, *, #, OK, 1, OK, STOP.