Xerox MF Series Technical Document page 64

D7
SUBJECT: M SUBJECT: M
Tools
• Phillips screwdriver.
Preliminary steps
• Remove the control panel / scanner chassis - printer (worksheet D5).
Disassembly
• Free the wires that supply the motor drive from their cable guide.
• Remove the two mounting screws. Disconnect the grounding lug.
• Remove the motor drive. Remove and keep the 44/18 pinion.
Motor drive
Assembly
• Unpack and visually inspect the new parts.
• Fit the 44/18 pinion on the motor drive.
• Pass the wires in the wire guide. Connect the grounding lug in the original location.
• Screw in and tighten the two mounting screws.
- 16 -
OTOR DRIVE OTOR DRIVE
MG 252 787 467 - A
44/18 pinion
Mounting screws