Xerox MF Series Technical Document page 53

Code 03 - Stopped by operator
Communication stopped by the operator by pressing the
Code 04 - Programmed number invalid
Invalid single-key or quick-dial number: check the number (for example, a delayed transmission has
been programmed with a single key and the number corresponding to this key has been deleted).
Code 05 - Scanning fault
An incident has occurred at the location of the document to be transmitted. For example, the sheet is
jammed.
Code 06 - Printer not available
An incident has occurred on the printer: out of paper, paper jam or cover open. In the case of a recep-
tion, this incident code only appears if the "reception without paper" parameter is set to WITHOUT
PAPER.
Code 07 - Disconnect
The communication has been cut (bad connection).
Code 08 - Quality
This code generally indicates line quality problems. The document that you have transmitted has not
been received correctly. Contact your correspondent to check whether it is necessary to retransmit the
document: the interference may have occurred in an unimportant area of the document.
Code 0A - No document to recover
You have attempted to recover a document from a correspondent, but the latter has not prepared (stored)
the document or the password that was entered is wrong.
Code 0B - Wrong number of pages
There is a difference between the number of pages indicated when the document was prepared for trans-
mission and the number of pages actually transmitted: check the number of pages of the document.
Code 0C - Received document faulty
Ask the correspondent who calls you to check the length of his document (it is too long to be received in
its entirety).
Code 0D - Document transmission fault
Ask the correspondent who calls you to retransmit his document.
Code 13 - Memory full
Your fax can no longer receive incoming documents because the memory is full: there are too many
documents that have been received but not yet printed, or there are too many documents waiting to be
transmitted.
Print the received documents, and delete or transmit in immediate mode the documents waiting to be
transmitted.
Code 14 - Memory full
Received document memory saturated. Restore the printer to working order.
Code 15 - Mailbox number x unknown
You want to deposit a document in a mailbox of a correspondent, but the mailbox with this number does
not exist with this correspondent.
Code 16 - List number x not retransmitted
You have requested the retransmission of a document by a remote fax, but the latter has not pro-
grammed the requested list of recipients.
- 5 -
key.
MG 252 787 467 - A