Xerox MF Series Technical Document page 60

D3
SUBJECT: C
• Lift the control panel at its upper left-hand corner (D), hold it and apply a medium amount of
pressure halfway down its side (E), then free the left-hand side of the control panel by pushing
downwards (F). Disconnect the control panel flat cable and remove the control panel.
• Disconnect the flat cable of the display, and the loudspeaker connector.
• Remove the eight mounting screws of the control panel board. Remove the control panel board,
the elastomer, the display, the glass and the equipped top cover.
Assembly
• Unpack and visually inspect the new parts.
• Put the new parts in place on the equipped top cover in the following order: glass, display, elas-
tomer and control panel circuit board. Screw in and tighten the eight mounting screws.
• Connect the connectors of the loudspeaker and of the display.
• Connect the CIS flat cable to the connector on the control panel board.
• Position the lower part of the control panel on the chassis and clip it in place. Press down on the
upper part of the control panel to complete the assembly.
Mounting screws
Control panel board
Elastomer
Display
Display window
Equipped top cover
- 12 -
- C
ONTROL PANEL
- G - T
PLAY LASS OP COVER WITH LOUDSPEAKER
- E
IRCUIT BOARD LASTOMER
MG 252 787 467 - A
- D -
IS
( ' )
CONT D