Bosch Rexroth Rho 4.0 Connectivity Manual page 16

1−6 Bosch Rexroth AG
Safety Instructions
Electric Drives
and Controls
CAUTION
Danger to the module!
Do not insert or remove the module while the controller is
switched ON! This may destroy the module. Prior to inserting or
removing the module, switch OFF or remove the power supply mo-
dule of the controller, external power supply and signal voltage!
CAUTION
use only spare parts approved by Rexroth!
CAUTION
Danger to the module!
All ESD protection measures must be observed when using the
module! Prevent electrostatic discharges!
The following protective measures must be observed for modules and
components sensitive to electrostatic discharge (ESD)!
D Personnel responsible for storage, transport, and handling must have
training in ESD protection.
D ESD-sensitive components must be stored and transported in the
prescribed protective packaging.
D ESD-sensitive components may only be handled at special ESD-
workplaces.
D Personnel, working surfaces, as well as all equipment and tools
which may come into contact with ESD-sensitive components must
have the same potential (e.g. by grounding).
D Wear an approved grounding bracelet. The grounding bracelet must
be connected with the working surface through a cable with an inte-
grated 1 MW resistor.
D ESD-sensitive components may by no means come into contact with
chargeable objects, including most plastic materials.
D When ESD-sensitive components are installed in or removed from
equipment, the equipment must be de-energized.
RhoMotion 1070072365 / 04