Talm Settings; Network Settings - FOR-A MFR Series Operation Manual

9-3. TALM Settings

9-3-1. Network Settings

The MFR-TALM Network Settings page allows you to set network settings on an MFR-TALM
unit.

Factory Default Settings
Default user name and password settings for logging into an MFR-TALM unit are as shown
below. User name:
Password:
To change the user name and password, proceed as follows:

Changing PC-LAN Settings
1. Refer to the table below to change the desired settings.
Parameter
IP
Configuration
User Setting
2. Click Send.
3. A dialog box appears. Click OK to restart Web-Based Control.
NOTE
Make sure to enter the User name, even when you change the Password.

Changing MFR-LAN Settings
1. Set the new MFR-LAN IP address and Subnet Mask settings.
2. Click Send.
3. Restart the MFR-TALM unit. (Turn the MFR-TALM power OFF then ON.)
user (factory default setting)
password (factory default setting)
IP Address Allows you to enter the IP address.
Subnet Mask Allows you to enter the Subnet Mask.
Default Gateway Allows you to enter the Default Gateway address.
User Name Allows you to set the Username used in the login
page.
Password Allows you to enter the Password.
Re-enter Password Allows you to reenter the Password.
89
Description