Snmp/Sntp Settings - FOR-A MFR Series Operation Manual

To change the User Name and Password, proceed as follows:

Changing PC-LAN Settings
1. Refer to the table below to change the desired settings.
Parameter
IP Configuration IP Address
Subnet Mask
Default Gateway
User Setting User Name
Password
Re-enter
Password
2. Click Send.
3. A dialog box appears. Click OK to restart Web-Based Control.
IMPORTANT
Saved settings are applied the next time Web-Based Control is restarted. (Restarting the
browser without pressing OK on the dialog does not apply the settings.) To apply settings in
such case, click the Restart button and close the browser.
* It takes about several tens of seconds to restart Web-Based Control.
NOTE
Make sure to enter the User name, even when you change the Password. If an invalid name
is entered, User Name or Password are not changed.

4-1-8. SNMP/SNTP Settings

The SNMP/SNTP Settings page allows you to configure SNMP/SNTP settings.
Description
Allows you to enter the IP address.
Allows you to enter the Subnet Mask.
Allows you to enter the Default Gateway address.
Allows you to set the User Name used in the login
page.
Allows you to enter the Password.
Allows you to reenter the Password.
24