Gearbox Settings; Gearbox Settings Page - FOR-A MFR Series Operation Manual

5-8. Gearbox Settings

5-8-1. Gearbox Settings Page

The Gearbox Settings page allows you to set conversion, synchronization and delay for
gearbox features in optional MFR-8SDIGB / MFR-8SDOGB (for MFR-3000) and
MFR-16SDIGB / MFR-16SDOGB (for MFR-5000/8000) cards.
Note that two gearboxes are available by MFR-8SDIGB / MFR-8SDOGB cards (MFR-3000)
and four gearboxes by MFR-16SDIGB / MFR-16SDOGB cards (MFR-5000/8000).
Frame Rate
Selection
Synchronization
Method Selection
Input/Output
Signal Delay
Selection for each
Gearbox

Frame Rate Selection
Select a frame rate from 59.94p or 50p in the upper left corner of each card block. Different
rate from selected System Format setting under the MU Settings page can be selected.

Output Signal Selection
<Test Pattern Output>
Select the Internal tab and check Enable. Select a Test Pattern to output. Select an output
signal format from the To box on the Convert tab. (When 12G-SDI is selected, a test signal
outputs from A (on MFR-5000) or D (on MFR-3000/8000) port and 3G-SDI Test Patterns are
output from other BNC ports.
Input card
Select H delay.
Setting in One
Operation
Gearbox 1
Gearbox 2
76
Output card
Gearbox 1
Gearbox 2