Sun Microsystems SPARC Enterprise M8000 Product Notes page 31

Hide thumbs Also See for SPARC Enterprise M8000:
Table of Contents

Advertisement

Solaris OS Issues and Workarounds Fixed in Solaris 10 5/08 (3 of 4)
TABLE 6
CR ID
Description
6559504
Messages of the form nxge: NOTICE:
nxge_ipp_eccue_valid_check: rd_ptr
= nnn wr_ptr = nnn will be observed on
the console with the following cards:
• X4447A-Z, PCI-e Quad-port Gigabit Ethernet
Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
6563785
Hot-plug operation with the following cards
might fail if a card is disconnected and then
immediately reconnected:
• SG-XPCIE2SCSIU320Z
PCI-E Dual-Port Ultra320 SCSI HBA
• SGXPCI2SCSILM320-Z
PCI Dual-Port Ultra320 SCSI HBA
6564934
Performing a DR deleteboard operation on
a board which includes Permanent Memory
when using the following network cards
results in broken connections:
• X4447A-Z, PCI-e Quad-port Gigabit Ethernet
Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
6568417
After a successful CPU DR deleteboard
operation, the system panics when the
following network interfaces are in use:
• X4447A-Z, PCI-e Quad-port Gigabit Ethernet
Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
6571370
Use of the following cards have been
observed to cause data corruption in stress
test under laboratory conditions:
• X4447A-Z, PCI-e Quad-port Gigabit Ethernet
Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
Workaround
These messages can be safely ignored.
After disconnecting a card, wait for a few
seconds before re-connecting.
Sun StorageTek
Sun StorageTek
Reconfigure the affected network interfaces
after the completion of the DR operation. For
basic network configuration procedures, refer to
the ifconfig man page for more information.
Add the following line to /etc/system and
reboot the system:
set ip:ip_soft_rings_cnt=0
Add the following line in /etc/system and
reboot the system:
set nxge:nxge_rx_threshold_hi=0
Sun SPARC Enterprise M8000/M9000 Servers Product Notes
17

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SPARC Enterprise M8000 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Sparc enterprise m9000

Table of Contents