Adding Sparc64 Vii Processors To An Existing Domain - Sun Microsystems SPARC Enterprise M8000 Product Notes

16. Confirm that the target domain has been correctly started.
XSCF> showlogs power
17. Use the showlogs(8)and showstatus(8) commands to confirm that no
abnormality has occurred.
XSCF> showlogs error -v
XSCF> showstatus
18. Install a version of Solaris OS that supports SPARC64 VII processors.
Refer to
about supported software versions.
If you are installing Solaris 10 8/07 on the new domain, you must install from a
patched image on the installation server. For information about patches required
to run Solaris 10 8/07 with SPARC64 VII processors, refer to
for Solaris 10 8/07 with SPARC64 VII CPUs" on page
network-based installations, refer to Solaris 10 8/07 Installation Guide: Network-
Based Installations (part 820-0177).
19. Use the setdomainmode(8) command to enable the autoboot function of the
domain.
The autoboot function is applied by a domain reboot. For more information, refer
to the SPARC Enterprise M4000/M5000/M8000/M9000 Servers XSCF User's Guide
and the setdomainmode(8) man page.
Adding SPARC64 VII Processors to an Existing
Domain
You can add SPARC64 VII processors to an existing domain using one of the
following approaches:
Adding the processors using dynamic reconfiguration (DR)
■
If you are already running versions of XCP firmware and Solaris OS that support
SPARC64 VII processors, then you can add the processors to an existing domain
using DR. For information about minimum supported versions of firmware and
software, refer to
information about DR, refer to the SPARC Enterprise M4000/M5000/M8000/M9000
Servers Dynamic Reconfiguration (DR) User's Guide.
30 SPARC Enterprise M8000/M9000 Servers Product Notes for XCP 1071 • July 2008
"Supported Firmware and Software Versions" on page 2
"Supported Firmware and Software Versions" on page
for information
"Required Patches
3. For information about
2. For