Nortel 8000 Series Installing And Maintaining page 54

54 8010co chassis installation
Prerequisites
•
Procedure steps
Step
1
2
3
4
Installing and Maintaining the Ethernet Routing Switch 8000 Series Chassis
Copyright © 2008, Nortel Networks
.
To mount the 8010co chassis in a Hendry rack, you need the following
equipment:
— Installation shelf (shipped with the 8010co chassis)
— 12 hex-head screws and a nutdriver
— A Phillips screwdriver
Action
Place the installation shelf at the bottom of the rack.
Hold the installation shelf in position and align the mounting rail with
the two holes on either side of the vertical rack support.
Insert a hex-head screw through the mounting hole of each
installation shelf and into the corresponding hole in the rack.
For more information about installing the shelf, see
installation shelf in a Hendry rack" (page
Installing the installation shelf in a Hendry rack
Tighten each screw with a nutdriver.
Nortel Ethernet Routing Switch 8600
NN46205-303 01.02 Standard
4.1 10 January 2008
"Installing the
54).