Nortel 8000 Series Installing And Maintaining page 50

50 8010co chassis installation
Prerequisites
•
Procedure steps
Step
1
2
3
4
5
Installing and Maintaining the Ethernet Routing Switch 8000 Series Chassis
Copyright © 2008, Nortel Networks
.
To mount the 8010co chassis in a two-post rack, you need the following
equipment:
— Installation shelf (shipped with the 8010co chassis)
— A standard 19-in. or 23-in. equipment rack
Attach the clip nuts shipped with the 8010co chassis, if necessary.
— 12 Phillips screws and a Phillips screwdriver
Action
Place the installation shelf at the bottom of the rack inside the rails.
Hold the installation shelf in position and align the mounting rail with
the two holes on each side of the vertical rack support.
Insert a Phillips screw through each installation shelf mounting hole
and into the corresponding hole in the rack.
For more information about installing the shelf, see
installation shelf in a 19-in. equipment rack" (page
Installing the installation shelf in a 19-in. equipment rack
Add a hex nut to each screw and tighten by using a hex wrench.
Tighten each screw with a Phillips screwdriver.
Nortel Ethernet Routing Switch 8600
NN46205-303 01.02 Standard
4.1 10 January 2008
"Installing the
50).