Labom CI4 Series Operating Instructions Manual page 26

6.5.5 "Display" menue
In the "Display" menue, you find all the settings that affect the display on the screen.
Menue entry
Language
Units
Display mode
Decimal point
Backlight
6.5.5.1 "Units" submenue
You can select the unit of every value shown on the display. These settings do not affect
the internal calculations of the device.
The shown conversions are only meant for your orientation. The device uses conversion
values with ten decimal places.
The unit selection in this submenue only affects the display on the screen. Communication
via HART is performed using the unit set in the HART driver.
Fill height unit
The unit in which the measured fill height should be displayed can be selected from the
following list. This is also the unit for the height offset.
Unit
mm
cm
m
ft
in
yd
BA_078 Rev 1F6 Level transmitter PASCAL Ci4 LEVEL
Description
Select menue language
Setting units for the different measured and displayed values
Configuration of the display layout and content (see 6.3.4)
Select setting of decimal point to determine number of decimal
places
Switch backlight on/off
Table 14: "Display" menue
Description
Millimetre (1 mm = 0.001 m)
Centimetre (1 cm = 10 mm = 0.01 m)
Metre (1 m = 100 cm = 1000 mm)
Foot (1ft = 12 in = 30.48 cm)
Inch (1 in = 1/12 ft = 25.4 mm)
Yard (1 yd = 3 ft = 36 in = 0.9144 m)
Table 15: Possible fill height units
Page 26/36