Table of Contents
Advertisement
Quick Links
Operating Instructions
1 General Information....................................................................................................... 2
1.1 General Safety Notes .............................................................................................. 2
1.2 Intended Use ........................................................................................................... 2
1.3 Conformity with EU Regulations .............................................................................. 2
1.4 EX Approval ............................................................................................................ 2
2 Transportation and Storage .......................................................................................... 2
3 Installation and Commissioning .................................................................................. 2
3.1 Mechanical Installation ............................................................................................ 3
3.2 Electrical Connection .............................................................................................. 3
4 Operation ........................................................................................................................ 3
4.1 Zero-point setting .................................................................................................... 3
4.2 Devices with Diaphragm Seal ................................................................................. 4
4.3 Maintenance / Service ............................................................................................. 4
5 Disassembly ................................................................................................................... 5
LABOM Mess- und Regeltechnik GmbH Im Gewerbepark 13 27798 Hude Germany
Hotline: +49 4408 804-444 Fax: +49 4408 804-100 e-mail: sales@labom.com www.labom.com
Pressure transmitter with bourdon tube
Type series CK5xxx
BA_032_en_2021-11_10.01
Page 1/5
Advertisement
Table of Contents
Related Manuals for Labom CK5 Series
Summary of Contents for Labom CK5 Series
- Page 1 4.2 Devices with Diaphragm Seal ................. 4 4.3 Maintenance / Service ..................... 4 5 Disassembly ........................5 LABOM Mess- und Regeltechnik GmbH Im Gewerbepark 13 27798 Hude Germany BA_032_en_2021-11_10.01 Hotline: +49 4408 804-444 Fax: +49 4408 804-100 e-mail: sales@labom.com www.labom.com...
- Page 2 In addition to this instruction, be sure to observe all statutory requirements, applica- ble standards, the additional technical specifications on the accompanying data sheet (see www.labom.com) as well as the specifications indicated on the type plate. General Safety Notes The installation, set up, service or disassembly of this device must only be done by trained, qualified personnel using suitable equipment and authorized to do so.
- Page 3 (see figure 1). You can find further information about zero- adjustment of pressure gauge with micro adjustment pointer in the document TA_029 on www.labom.com. Figure 1: Zero-point correction BA_032_en_2021-11_10.01 Pressure transmitter with bourdon tube Page 3/5...
- Page 4 4.1.2 Adjusting the angle-of-rotation sensor For adjustable devices the adjustment re- quires to apply the lower limit pressure re- spectively the upper limit pressure to the de- vice. Bring the enclosed or another magnet in the alignment position (see picture) to ad- just accordingly.
- Page 5 Disassembly When measuring hot media, make sure that the device has cooled down prior to any dis- mounting or wear appropriate protective clothing to avoid burns. Switch off the power supply to the device before disconnecting the electrical connections. Once this is done, the device may be mechanically removed. Warning Opening pressurized lines might cause severe injuries.
Need help?
Do you have a question about the CK5 Series and is the answer not in the manual?
Questions and answers