General Information; General Safety Notes; Intended Use; Conformity With Eu Regulations - Labom CI4 Series Operating Instructions Manual

1

General Information

This document contains necessary information for the proper installation and use of this
device. In addition to this instruction, be sure to observe all statutory requirements, appli-
cable standards, the additional technical specifications on the accompanying data sheet
(see www.labom.com) as well as the specifications indicated on the type plate.
1.1

General Safety Notes

The installation, set up, service or disassembly of this device must only be done by
trained, qualified personnel using suitable equipment and authorized to do so.
Warning
Media can escape if unsuitable devices are used or if the installation is not
correct.
Danger of severe injury or damage
Ensure that the device is suitable for the process and undamaged.
1.2

Intended Use

The device is intended to measure pressure of gases, vapors and liquids as specified in
the data sheet.
1.3

Conformity with EU Regulations

The CE-marking on the device certifies its compliance with the applicable EU Directives for
placing products on the market within the European Union.
The following guidelines apply to these devices:
ATEX Directive
EMC Directive
PED Directive
You find the complete EU Declaration of Conformity (document no. KE_042) at
www.labom.com.
1.4

ATEX Approval

If you purchased a device with ATEX approval, please refer to the accompanying docu-
ment XA_010 or XA_011 for ATEX-relevant information.
2

Transportation and Storage

Store and transport the device only under clean and dry conditions preferably in the origi-
nal packaging. Avoid exposure to shocks and excessive vibrations.
Permissible storage temperature:
3

Installation and Commissioning

Ensure that the device is suitable for the intended application with respect to pressure
range, overpressure limit, media compatibility, temperature range and process connection.
After the mechanical installation and electrical connection is completed, the device is
ready for operation as soon as the power supply is switched on.
BA_078 Rev 1F6 Level transmitter PASCAL Ci4 LEVEL
2014/34/EU
2014/30/EU
2014/68/EU
-40...80 °C
Page 2/36