Initial Setup; Setup Room Id - Honeywell INNCOM e7w User Manual

INNCOM e7w THERMOSTAT USER GUIDE

Initial Setup

Before going through the initial setup sequences, ensure that thermostat is mounted and con-
nected to the smart wall plate.
When you run the newly programmed e7w, it will proceed into Initialization Mode In the Initial-
ization Mode you need to configure Room ID, PAN ID and RF Channel in the e7w.
Note:
•
When properly connected, the thermostat will proceed into Initialization Mode and display
rId.
• When not properly connected to the smart wall plate, an alert message will be displayed
until the smart wall plate is properly connected.
If you see SWp on the display, most likely the unit is not connected or fitted on the smart wall
plate. Unscrew the captive screws and re-fit the thermostat. Once properly connected, the dis-
play will start up as rId. Avoid over-tightening of screws and irregularity on the wall surface
that may lead to an insecure connection between the smart wall plate and thermostat.

Setup Room ID

1. Once rld and "—"is displayed, press the MODE button. The default 65535 Room ID will scroll
across the screen — one numerical setting at a time, from highest to lowest (extreme left to
right value). After the current value finishes scrolling, the 3 vertical Fan speed dots displays
indicating the high digit is displayed.
31-00302-01
Figure 8: Setup Room ID
20