Honeywell INNCOM e7w User Manual page 20

INNCOM e7w THERMOSTAT USER GUIDE
1
2
3
4
5
6
31-00302-01
Target Temperature
Displays the current value of the desired temperature (SET). Also used to
display parameter in service mode.
Other Temperature
Displays the measured value of inside temperature, and outside temper-
ature when configured. Also, it displays the parameter value in service
mode.
Fan Speed
Displays the fan speed, there are five modes of fan speed.
Auto
Auto Fan Speed – Fan speed and heating or cooling are automatically
selected to raise, or lower room temperature based on the difference be-
tween the desired (SET) temperature shown on the display and the
measured room temperature.
Low/Medium/High Fan Speed – Low, Medium, and High fan speeds
are selected by pressing the fan button. The fan will run at the selected
speed in heating or cooling, in order to maintain desired (SET) tempera-
ture.
Heat Mode
Heat mode displayed, when the thermostat is configured only for heat
mode.
Cool Mode
Cool mode display, when the thermostat is configured only for cool
mode.
Outside Temperature
The outside temperature icon will be displayed next to the small seven
segment characters displaying the temperature, when outside air tem-
perature is enabled. Outside air temperature is displayed in dormant
mode only.
Note: This symbol also appears, when using the rEG CBL32 Registry Ed-
itor feature of the e7w to indicate a registry has been modified and
needs to be stored.
14
Off Low
Off Low Fan Medium Fan
Hi
Med
High Fan