Initial Setup; Setup Room Id - Honeywell e7w Installation Instructions Manual

e7w WIRELESS EMS THERMOSTAT - INSTALLATION INSTRUCTIONS

INITIAL SETUP

Before going through the initial setup se-
quences, ensure the thermostat is mounted and
connected to the Smart Wall.
Note:
− When properly connected, the thermo-
stat will proceed into INTIALIZATION
MODE and display rId.
−
When not properly connected to the
Smart Wall Plate, the unit will display
the alert message SWp and the alert
icon will illuminate until the Smart Wall
Plate is connected.
If you see SWp on the display, most likely the
unit is not connected or properly seated on the
Smart Wall Plate. Unscrew the captive screws
and re-seat the thermostat. Once properly
connected, the display will start up as noted.
Take care not to over-tighten the screws and
note any irregularity on the wall surface that
may lead to an insecure connection between
the Smart Wall Plate and thermostat.

Setup Room ID

Figure 6. Setup Room ID
1. Once rld is displayed, press MODE. The de-
fault Room ID value (65535) is displayed and
will begin scrolling across the screen one nu-
merical setting at a time, from highest to low-
est (left most to right most value).
31-00308-01
Note:
The five-digit number is comprised of three
fields: highest digit, middle two digits, low-
est two digits (HIMEDLO), default value
(65535). Three settings must be made.
2. In HI (high) value page, use the UP/DOWN
arrow buttons to change this value (range is
0-6). Press FAN to continue.
3. Set the MED (medium) values in the se-
quence using the UP/DOWN arrow buttons
(range is 0-99). Press FAN to continue.
4. Repeat the same step for the LO (low) two
values (range is 0-99) and press FAN to con-
tinue. Press MODE to accept the value.
5. The new ID number scrolls across the dis-
play. The unit beeps to confirm the value is
stored to memory. Once the scrolling is com-
pleted, screen will return to INTIALIZATION
MODE.
6. If you want to continue, press the DOWN ar-
row button to display rF mode (RF channel
for IRAS communication).
Or
If you want to exit the INTIALIZATION MODE,
press the FC key.
After you configured ROOM ID, you need to
configure RF channel for IRAS communica-
tion.
Figure 7. Configuring Room ID
6