Otto Bock 4X889-1 Instructions For Use Manual page 14

6) In case of collision:
Check the positioning of the product on the prosthetic knee joint and
correct.
If the collision cannot be remedied by changing the positioning, qualified
personnel must remedy the collision according to the section "Prepara­
tion for use" (see Page 12) – heading "Fitting the product to the pros­
thesis".
Handling during charging
1) Starting from the medial side, thread the charging adapter
the prosthetic knee joint
2) Verify that the charging adapter
knee joint
3) Charge the prosthetic knee joint according to its instructions for use.
Removing the product from the prosthesis
1) Pull the rubber closure
2) NOTICE! Do not overstretch the product.
Bend the product apart (see fig. 7).
3) NOTICE! Work carefully so as to not damage the prosthetic joint.
Remove the product from the prosthetic knee joint.
6.2 Cleaning
NOTICE
Use of unsuitable cleaning agents or disinfectants
Impairment of functionality and damage due to incorrect cleaning agents or
disinfectants
► Only clean the product with the approved cleaning agents.
► Only disinfect the product with the approved disinfectants.
► Observe the instructions for cleaning and care.
► Inform the patient.
Washing-up liquid, neutral soap
Hand sanitiser (fragrance-free, alcohol-free)
14 | Ottobock
and the product
(see fig. 5).
off the pad button
Approved cleaning agents
Approved disinfectants
(see fig. 4).
is correctly fitted to the prosthetic
(see fig. 6).
between