Figure 8-26 Scsi Backplane Sockets And Connectors - Sun Microsystems SPARCstation 20 Service Manual

Single-connector
drive sockets
SCSI Backplane Sockets and Connectors
FIGURE 8-26
5. Remove the two Phillips-head screws that secure the SCSI backplane to the
plastic mounting bracket (
Note – The DC power socket and the SCSI data socket are located on the right side
of the SCSI backplane. This part of the SCSI backplane extends through a slot in the
drive bracket.
6. Grasp the left edge of the SCSI backplane and rotate it away from the chassis.
7. Pull the end of the backplane with the SCSI data socket and the DC power socket
out through the drive bracket area.
8. Remove the SCSI backplane from the chassis.
).
FIGURE 8-27
Chapter 8 Removing and Installing Subassemblies
SCSI data
socket
DC power
socket
SCSI data
connector
DC power
connector clip
85