Sun Microsystems SPARCstation 20 Service Manual page 13

Internal Cables and DC Power Connector (SunCD 2Plus Drive-Type Chassis) 89
FIGURE 8-29
Back Panel SBus Slots and Captive Screws 90
FIGURE 8-30
SCSI Backplane, SCSI Data, and DC Power Connectors 90
FIGURE 8-31
Cable Guide Detail 92
FIGURE 8-32
Internal Cables and DC Power Connector (SunCD 4 Drive-Type Chassis) 94
FIGURE 8-33
Removing the System Board 95
FIGURE 8-34
Attaching a Wrist Strap to Back Panel and Removing the Power Supply 98
FIGURE 8-35
Internal Cables and DC Power Connector (SunCD 2Plus Drive-Type Chassis) 99
FIGURE 8-36
Back Panel SBus Slots and Captive Screws 100
FIGURE 8-37
Detail of Cable Guide 101
FIGURE 8-38
SCSI Backplane, SCSI Data, and DC Power Connectors 102
FIGURE 8-39
Internal Cables and DC Power Connector (SunCD 4 Drive-Type Chassis) 104
FIGURE 8-40
Back Panel Captive Screws 104
FIGURE 8-41
Removing the System Board 105
FIGURE 8-42
Diskette Drive Cable Location 109
FIGURE 8-43
Diskette Drive Cable Plastic Tab 109
FIGURE 8-44
Pulling the Diskette Drive Cable Through the Drive Bracket Opening 110
FIGURE 8-45
System Board Cable Routing (SunCD 4 Drive-Type Chassis) 112
FIGURE 8-46
Location of Hard Disk Drives 118
FIGURE 9-1
Single Connector Hard Disk Drive 119
FIGURE 9-2
Removing a Hard Disk Drive 120
FIGURE 9-3
Installing a Hard Disk Drive 122
FIGURE 9-4
Removing the CD-ROM Drive 124
FIGURE 9-5
SunCD 2Plus Rear View and Jumper Settings 125
FIGURE 9-6
SunCD 4 Drive Rear View and Jumper Settings 125
FIGURE 9-7
Installing a CD-ROM Drive 126
FIGURE 9-8
Diskette Drive Location 127
FIGURE 9-9
CD-ROM Drive Filler Panel 128
FIGURE 9-10
Figures xiii