Maxxus Multipress 9.1 Installation Manual page 11

Assembly - Multipress
Assembly Step 5
Loosen and take out the three single rollers (R1, R2 & R4) from the frame.
Connect the end of the traction cable (55) to the mount on the weight slide.
Feed the traction cable (55) through the single roller (R1) and mount the single roller (R1) back onto the
T-frame.
Now feed the traction cable (55) through the single roller (R2) and single roller (R4). Then mount both rollers
(R2 & R4) back onto the frame.
Loosen the upper roller (R3) on the double roller (57). Pull the traction cable (55) down to form a loop large
enough below the single roller (R2) to fit the (R3) roller into. Then mount this back onto the top roller holder of
the double roller (57).
Then fix the end of the traction cable (55) to the double roller mount with fixing (56)
Double Roller, parallel (57) Double Roller with fixing (56)
Traction Cable (55) – Length 2,515 mm
10
10
10
R1
ENG
R2
R4
R3
11