Fitting The Furniture Doors - Miele KFNS 37692 iDE Operating And Installation Instructions

Installation

Fitting the furniture doors

The upper edge of the appliance
furniture door should be aligned with
the height of the furniture doors of the
adjacent kitchen units.
The furniture door must be mounted
plane and free of tension.
The following chapter describes the
installation of furniture doors with a
furniture front of at least 16-19 mm
thickness.
Carry out the following steps on both
doors.
 A gap of 8 mm is set at the factory
between the appliance door and the
fixing bracket. Check this distance
and adjust it if necessary.
 Push the fitting aids  up to the
height of the furniture door: the lower
edge X of the fitting aids must be at
the same height as the upper edge of
the furniture door being fitted (see 
in diagram).
102
Useful tip: Push up the fitting aids with
the furniture front until they are at the
same height as the doors of adjacent
kitchen units.
 Undo the nuts  and take the fixing
bracket  off together with the fitting
aids .