Fitting The Furniture Doors - Miele KFN 37432 iD Operating And Installation Instructions

For additional stability of the
appliance in the unit, push the rods
supplied in underneath the appliance
between it and the floor of the housing
unit:
 Then secure handle  to one of the
rods .
 Use the handle to push the rod into
the guide as far as it will go. Remove
the handle and fit it to the other rod
and push this into its guide as far as it
will go. Important! Keep the handle
somewhere safe in case you ever
need to fit the appliance into a new
housing unit
 Close the appliance doors.

Fitting the furniture doors

The upper edge of the appliance
furniture doors should be aligned with
the height of the furniture doors of the
adjacent kitchen units.
The furniture doors must be mounted
free of tension.
The following chapter describes the
installation of furniture doors with a
furniture front of at least 16-19 mm
thickness.
Carry out the following steps on both
doors.
 The distance between the appliance
door and the fixing bracket is set to
8 mm at the factory. Check this
distance and adjust it if necessary.
 Push the fitting aids  up to the
height of the furniture door: the lower
edge X of the fitting aids must be at
the same height as the upper edge of
the furniture door being fitted (see 
in diagram).
Installation
95