Fitting The Furniture Doors - Miele KFNS 37432 iD Operating And Installation Instructions

Installing the appliance
For additional stability of the appliance
in the unit, push the rods supplied in
underneath the appliance between it
and the floor of the housing unit:
 First secure the handle  to one of
the rods .
 Use the handle to push the rod into
the guide as far as it will go. Remove
the handle and fit it to the other rod
and push this into its guide as far as it
will go.
Important: Keep the handle
somewhere safe in case you ever
need to fit the appliance into a new
housing unit.
 Close the appliance doors.
86

Fitting the furniture doors

The upper edge of the appliance
furniture door should be aligned with
the height of the furniture doors of the
adjacent kitchen units.
The furniture door must be mounted
plane and free of tension.
The following chapter describes the
installation of furniture doors with a
furniture front of at least 16-19 mm
thickness.
Carry out the following steps on both
doors.
 A gap of 8 mm is set at the factory
between the appliance door and the
fixing bracket. Double check this gap
and reset it if necessary.
 Push the fitting aids  up to the
height of the furniture door: the lower
edge X of the fitting aids must be at
the same height as the upper edge of
the furniture door being fitted (see 
in diagram).