Miele KFNS 37692 iDE Operating And Installation Instructions page 109

The fuse rating must be at least 10 A.
This appliance must be connected to a
suitable switched socket. The electrical
installation must be in compliance with
current local and national safety
regulations.
The socket must not be concealed
behind the appliance and must be
easily accessible so that the appliance
can be quickly disconnected from the
electricity supply in case of an
emergency.
If the socket is no longer accessible
after installation, an additional means of
disconnection must be provided for all
poles. Suitable means of disconnection
include switches with an all-pole
contact gap of at least 3 mm. These
include isolator switches, fuses and
relays.
The mains plug and mains connection
cable must not come into contact with
the back of the appliance as vibrations
can cause damage to these
components. This could result in a short
circuit.
Nor should other appliances be
plugged into a socket located directly
behind this appliance.
Do not connect the appliance to the
mains electricity supply using an
extension lead. Extension leads do not
guarantee the required safety of the
appliance (e.g. danger of overheating).
Do not connect the appliance to a
stand-alone inverter such as those used
with an autonomous energy source, e.g.
solar power.
When the appliance is switched on,
power surges could result in a safety
switch-off. This could damage the
electronics. The appliance must not be
used with so-called energy-saving
devices either. These reduce the
amount of energy supplied to the
appliance, causing it to overheat.
If the mains cable needs to be replaced,
this must be done by a qualified and
competent electrician.
Installation
109