Otto Bock 12R6 Series Instructions For Use Manual page 13

1.1 Construction and Function
The 12R6=* and 12R7=* modular kits and the 13R1=* elbow joint modular
kit are used for the prosthetic fitting of patients with amputations from the
level of the upper arm to the shoulder girdle. The focus is on a lightweight
prosthetic fitting. The modular kits contain structural components for the
alignment of an arm prosthesis. The modular elbow joint is included in the
modular kits. It can be adjusted to 7 locking positions.
Reference number
12R6=*
12R7=*
13R1=*
1.2 Combination possibilities
This prosthetic component is compatible with Ottobock's system of modular
connectors. Functionality with components of other manufacturers that have
compatible modular connectors has not been tested.
2 Intended use
2.1 Indications for use
The product is to be used solely for upper limb prosthetic fittings.
2.2 Area of application
The product serves to create passive arm prostheses.
2.3 Environmental conditions
Allowable environmental conditions
Temperature range for use: -10 °C to +45 °C
Relative humidity: max. 90%, non-condensing
Moisture: fresh water and salt water as splashing water, sweat
Unallowable environmental conditions
Mechanical vibrations or impacts
Acids
Dust, sand, highly hygroscopic particles (e.g. talcum), smoke
3 Safety
3.1 Explanation of warning symbols
Warning regarding possible risks of accident or injury.
CAUTION
Designation
Transhumeral modular kit
Shoulder disarticulation
modular kit
Modular elbow joint
Fitting
Upper arm amputation
Shoulder girdle amputation,
shoulder joint disarticulation
Component of the modular pros­
thesis
13