Dexter Laundry B Series Operators Manual Installation & Operation Instructions page 28

switch off, the dry cycle L.E.D. and programming L.E.D. will remain on, and the 4-digit numeric display will
change to "Prog".
12) Press and release the STOP key to save the cycle program and escape the programming mode. If you want
to change the same dry cycle program again, press the SELECT/ENTER key and continue at step 6 of this
procedure. If you want to modify another dry cycle program, go to step 4 of this procedure and continue.
13) If you pressed the STOP key to escape the programming mode, you may now start the dry cycle by pressing
the START key.
PERMANENT DRYER CONTROLLER PROGRAMMING EXAMPLE
REQUIREMENTS: Dry a load with 50 minutes of actual heat at 195
The following procedure will show you how to permanently modify the existing dry cycle 1 program for one
cycle of drying. It is based on the assumption that the factory defaults have not been permanently changed. If
they have been changed, the steps of this procedure will be the same, but the values that are displayed will be
different. The amount of times that the dryer controller touch pad UP or DOWN keys must be pressed and
released may also be different.
If you want the change to be temporary (for only one dry cycle), go to the "TEMPORARY DRYER CONTROLLER
PROGRAMMING" section of this manual.
1) After the load has been placed in the dryer, press and release the UP or DOWN touch pad key on
the dryer controller until the L.E.D. for dry cycle 1 is illuminated.
2) Press and release the PROG touch pad key on the dryer controller. The dryer controller display will
not change.
3) Immediately, press and release the UP arrow key on the dryer controller touch pad. The controller
display will change from "LOAd" to "Prog". You have now entered the permanent programming mode. The
dry time L.E.D. will remain on and the programming L.E.D. will illuminate.
4) Press and release the SELECT/ENTER touch pad key once. The dry time L.E.D. and programming
L.E.D. will remain on and the dry time L.E.D. will illuminate. The dryer controller will also show the number
"35".
5) Press the UP arrow touch pad key 18 times until the dryer controller display shows the number "53".
6) Press and release the SELECT/ENTER touch pad key once. The dry time L.E.D. and programming
L.E.D. will remain on and the dry time L.E.D. will switch off. The temperature L.E.D. will illuminate and the
dryer controller display will show the number "180".
7) Press and release the UP arrow touch pad key three times until the dryer controller display shows
the number "195".
8) Press and release the SELECT/ENTER touch pad key. The dry time L.E.D. and the programming
L.E.D. will remain on and the temperature L.E.D. will switch off. The cool down L.E.D. will illuminate and the
dryer controller display will show the number "5".
9) Press and release the DOWN arrow touch pad key twice until the dryer controller display shows the
number "3".
10) Press and release the SELECT/ENTER touch pad key. The dry time L.E.D. and the programming
L.E.D. will remain on and the cool down L.E.D. will switch off. The dryer controller display will change to
"Prog".
8514-265-001 REV C PAGE 28
º
F and three minutes of cool down.
PROCEDURE